Influence of clay minerals on the reduction of Cr6+ by citric acid

The influence of clay minerals on the reduction of Cr6+ by citric acid was investigated at pH values 4.0, 4.5 and 5.0 at 25 degrees C. The results indicate that montmorillonite and illite greatly accelerate the reduction reactions at pH 4.0 and 4.5, but their effects are dramatically reduced at pH 5.0. The role of clay minerals in accelerating the reactions is in the order: illite>montmorillonite>kaolinite, which has a positive correlation with the amount of Mn2+ adsorbed on the surfaces of these minerals. With light, Fe(3+) also significantly increases reaction rates. Ethylenediaminetetraacetic acid (EDTA) greatly suppresses the acceleration of the reduction reactions by these minerals, indicating that EDTA competes with citric acid for Mn2+. Thus, the formation of complexes between Mn(2+) and citric acid could be a prerequisite for the acceleration of the reductions of Cr6+ by clay minerals. In addition, there is no relationship between the specific surface area of clay minerals and the reduction rate of Cr6+ by citric acid.     

A comparison of the low frequency electrical signatures of iron oxide versus calcite precipitation in granular zero valent iron columns

Geophysical methods have been proposed as technologies for non-invasively monitoring geochemical alteration in permeable reactive barriers (PRBs). We conducted column experiments to investigate the effect of mineralogy on the electrical signatures resulting from iron corrosion and mineral precipitation in Fe0 columns using (a) Na2SO4, and (b) NaHCO3 plus CaCl2 mixture, solutions. At the influent interface where the reactions were most severe, a contrasting time-lapse electrical response was observed between the two columns. Solid phase analysis confirmed the formation of corrosion halos and increased mineralogical complexity in the corroded sections of the columns compared to the minimal/non-corroded sections. We attribute the contrasting time-lapse signatures to the differences in the electrical properties of the mineral phases formed within the two columns. While newly precipitated/transformed polarizable and semi-conductive iron oxides (mostly magnetite and green rust) increase the polarization and conductivity of the sulfate column, the decrease of both parameters in the bicarbonate column is attributed to the precipitation of non-polarizable and non-conductive calcite. Our results show that precipitate mineralogy is an important factor influencing the electrical properties of the corroded iron cores and must be considered if electrical geophysical methods are to be developed to monitor PRB barrier corrosion processes in situ.     

海洋石油工程清洁生产评估方法研究

从资源能源利用、废弃物产生、废弃物回收利用、污染物处理、环境管理效果和环境响应情况着手,建立了包括6个一级指标、29个二级指标的海洋石油工程清洁生产评估指标体系;研究利用专家调查和层次分析法确定各评估指标的权重值,探索评估指标的赋值方法、标准化方法,提出了海洋石油工程清洁生产综合指数计算方法体系。     

滤料粒径对BAF小尺度下流场形态及挂膜速度的影响

为探讨颗粒粒径对曝气生物滤池(BAF)运行效果的影响,采用数值模拟和实验研究方法分析了滤料粒径对曝气生物滤池流场形态及挂膜速度的作用机理.选用5个颗粒尺寸结构空间作为计算区域,利用Fluent软件对相同颗粒间隙、不同颗粒粒径下BAF小尺度下的流场形态进行模拟分析,并通过对3种粒径下流线图、速度矢量图、压力分布及湍流强度变化的对比分析,发现颗粒粒径为3 mm时流场形态最好,最有利于气水混合及氧传质的进行.同时,为验证模拟结果的正确性,对同种材质、相同运行条件下3种不同颗粒粒径进行挂膜速度对比,通过考察挂膜启动28 d的COD去除率变化及污泥生物量的对比分析,发现颗粒粒径为3 mm时,运行最为稳定,系统运行第16 d时就达到了80%的COD去除效率.     

阿哈水库浮游植物功能群时空分布特征及其影响因子分析

为了解贵州高原阿哈水库的浮游植物功能类群时空分布特征及其影响因素,于2012年至2013年枯水期(11月)、平水期(4月)、丰水期(7月)对浮游植物与水样进行分层采样分析.研究结果表明:浮游植物可分为23个功能群,优势功能群为B、D、J、LO、P、S1和X1,其时空分布特征表现为:枯水期、平水期与丰水期分别以B+D+P+LO、S1+LO以及S1为主,其丰度由枯水期至丰水期依次递增;优势功能群主要在15 m以下水体发生变化,营养物质分布差异及人工放闸泄水是产生该特征的主要原因;采样点大坝和库中的优势功能群季节变化大致相同,但却表现出大坝多于库中,而其丰度却低于库中的特征,水动力条件是导致这一变化的主要原因.经RDA分析得出,优势功能群丰度与水温呈正相关,与总氮、透明度、磷酸盐、硝氮呈负相关,其中水温、透明度为影响浮游植物功能群时空分布的主要因子.     

通过优化环境应力筛选提高电子产品可靠性

本文对国内环境应力筛选相关的标准进行了研究,通过理论计算和实际产品的试验验证两个维度对环境应力筛选进行了优化.结合我单位电路板的实际情况,研究了组件级别温度冲击中温度保持时间,温变率,温度循环次数等因素.通过对几组电路板组件温度冲击筛选度的计算,提出了最优温度循环次数的试验设计方法.通过两箱法对我公司的通信电子产品进行...     

基于MIKE 11的河网区域小型闸坝调控的水质响应模拟研究

闸坝运行是流域开发和利用中河流调节的主要形式之一,它改变了河流自然结构、流水过程及其相关环境.然而,目前很少有关于河网区域小型闸坝运行对水环境影响的分析.本研究利用MIKE11建立一维水动力与水质模型,以无锡市主要的污染物高锰酸盐指数,氨氮为指标,模拟闸坝调控模式下与无闸坝情景下无锡河网水质响应.研究表明：多个小型闸坝运行对河网区域内河流水质产生了负面影响,使城市河流高锰酸盐指数（COD_Mn）和氨氮（NH₃-N）浓度都有所上升;其中,闸坝调控对区域内河流上游水质的负面影响更为明显,对下游的则相对较小.在多小型闸坝运行下,河流上游的COD_Mn和NH₃-N总体浓度分别上升了12.89%和11.11%,下游的二者浓度分别上升了5.38%和7.27% .研究结果可为今后小型闸坝群的生态调控以及相关水环境响应研究提供了理论支撑和新思路.     

不同粒径微塑料对三氯生在热带爪蛙蝌蚪体内积累分布及其生态毒性的影响

三氯生（TCS）作为药物和个人护理品（PPCPs）中常见的抗菌剂,在水环境中存在与聚苯乙烯微塑料（PS-MPs）复合污染的生态健康风险.本研究旨在探究0.1、5、20 μm PS-MPs吸附TCS在蝌蚪体内累积情况,以及对蝌蚪毒性的作用.结果表明,PS-MPs吸附TCS在蝌蚪体内的积累能力依次为：TCS+5 μm PS组>TCS+20 μm PS组>TCS+0.1 μm PS组,累积量分别为3.27、1.8 mg·g^-1、无累积效应.值得注意的是,蝌蚪经不同粒径PS-MPs（2 mg·L^-1）、TCS（1 μg·L^-1）单独及复合暴露7 d后,各实验组脂质代谢水平均表现出丙酮酸含量增加（p<0.05）、甘油三酯含量降低（p<0.05）的趋势.复合组中TCS+0.1 μm PS组蝌蚪体内丙酮酸（Pyruvate）含量上升水平最显著（p<0.05）;TCS+20 μm PS组蝌蚪体内甘油三酯（TG）含量下降水平最显著（p<0.05）,这可能与脂代谢调控基因ppar-α、cpt1-β表达水平显著提升有关（p<0.05）.此外,PS-MPs、TCS单一和复合暴露 还会增加蝌蚪体内CAT、SOD酶活性.与脂质代谢结果不同的是,复合组中TCS+5 μm PS组蝌蚪体内CAT、SOD酶活性上升最显著（p<0.05）,这可能与调控基因cat、sod表达水平显著提升有关（p<0.05）.研究表明,复合暴露组对蝌蚪生理水平的影响高于单一暴露组,而不同复合处理组对蝌蚪脂质代谢水平和抗氧化水平影响具有差异,该结果可为评估微塑料（MPs）吸附亲脂性污染物对水生动物的毒性效应和生态风险提供 信息和参考.     

水资源生态足迹分析——以安康市为例

根据生态足迹分析方法,建立了水资源生态足迹概念模型,确定了计算水资源帐户生态足迹所需的3个关键参数,即平均水资源产量、均衡因子和地区产量因子,计算了安康市1996—2007年水资源生态足迹和生态承载力。引入水资源生态足迹压力指数、万元GDP水资源生态足迹、累积水资源生态足迹等指标,利用水足迹模型评价水资源可持续发展程度的全面性和对比性。结果表明,计算结果可客观评价安康市水资源可持续发展与利用情况,为地区水资源的可持续利用与管理提供了科学的依据。     

CDM Project Activities in China＇s Iron and Steel Industry：Current Status,Barriers and Development Strategies

China is now facing huge pressure from both the domestic concern of energy security and the global community's call for emission reduction commitment. As one of the major energy consumers and greenhouse gas emitters, China's iron and steel industry has a huge clean development mechanism (CDM) potential. This article both quantitatively and qualitatively analyzes the current status of CDM project activities in the iron and steel industry in China, including characteristics of approved project types, applicable methodologies, and potential technology fields. From the perspective of project implementation, the article summarizes development barriers such as high investment risk, difficulty in project identification, strict requirements on PPDs, long registration waiting time, and etc. Policy suggestions are also put forwarded to help better promote the development of CDM projects in the iron and steel industry.